Lead Flashing Replacement Across West Glamorgan

Code 4 & Code 5 lead flashing replacement. Mechanically fixed, properly pointed. written workmanship guarantee.

Call 07476 888638 for a free, no-obligation quote. Available Mon–Sun, 9am–6pm.

Lead Flashing Replacement

Failed lead flashing is the single most common cause of recurring roof leaks in West Glamorgan — chimney aprons that have lifted, soakers that have torn, abutment flashings that have pulled out of the mortar joint. Johnson's Roofing replaces lead flashing to LSA Code 4 and Code 5 standards, properly chased and pointed into the brickwork with lead-clipped mechanical fixings. Done once, done right. For lead used as the main covering on a bay or canopy, see lead roofing.

What the work covers

  • Code 4 & Code 5 milled lead to BS EN 12588
  • Chimney apron, back-gutter and soakers
  • Step-flashing dressed into chased brick joints
  • Lead valley re-lining
  • Lead-bayed abutment flashing for tile and slate
  • Lead patination oil to prevent white staining
  • Lead-clipped mechanical fixings (no reliance on mortar alone)
  • Removal and safe recycling of old lead
  • Sand-cement pointing with anti-shrink additive
  • written workmanship guarantee on lead-work

How we work

We strip the failed flashing back, rake out the brick joint to a minimum 25 mm depth, dress new Code 4 or Code 5 lead to the contour of the abutment, secure it with lead clips into the chase, and finally point the chase with sand-cement plus a flexible additive. Patination oil is applied on completion to prevent the white carbonate staining that disfigures fresh lead-work.

Common questions

Why does lead flashing fail?

Three main reasons: thermal movement opens the mortar pointing along the chase, lead is cut too short or in over-long bays so it cracks, or no mechanical fixings were used so wind eventually lifts it. We address all three on every job.

Code 4 or Code 5 — what's the difference?

Code 4 (1.80 mm thick) is the standard for chimney aprons, soakers and most domestic step-flashing. Code 5 (2.24 mm thick) is heavier-duty and used for back-gutters, valleys and longer runs. We specify the correct code for each location.

Can you re-use the old lead?

Almost never — by the time lead has failed it's usually work-hardened, split or torn. We strip it, weigh it and credit the recycle value against your invoice. Fresh milled lead is always our recommendation for a lasting repair.

How long should new lead flashing last?

Properly installed Code 4/5 lead-work to standard detailing has a service life of 60+ years. Our workmanship guarantee is provided in writing.

Get Your Free, Personalised Quote

Tell us about your roofing job and we'll get back to you as soon as possible.

No spam, no obligation. We'll get back to you as soon as possible.

Free Inspections
Fast Response
Reliable Workmanship
West Glamorgan Coverage