GRP fibreglass roofing across Swansea and Neath Port Talbot: new seamless GRP flat roofs and fibreglass roof repairs. Free inspection. Call 07476 888638.
Call 07476 888638 for a free, no-obligation quote. Available Mon–Sun, 9am–6pm.
GRP fibreglass roofing is a seamless, hard-wearing flat roof covering laid wet and cured on site. Johnson's Roofing installs new GRP flat roofs and repairs existing fibreglass roofs across Swansea and Neath Port Talbot, on garages, extensions, dormers, porches and balconies.
We inspect the roof and the deck underneath, then quote in writing. For a new GRP roof the old covering is stripped and a sound board deck laid. Edge trims go on first, then resin and a glass fibre mat are laid together and rolled out so no air is trapped. Once the laminate has cured, a topcoat seals the finish. GRP needs dry weather to lay, so we plan installation around the forecast.
GRP gives a flat roof a seamless, hard finish that suits roofs which are walked on or have awkward shapes. We lay new GRP roofs from the deck up and repair older fibreglass roofs where the damage is local.
Older fibreglass roofs usually fail for one of a few reasons: the laminate was too thin, it was laid onto a deck that moved or was damp, or the topcoat was left off or has worn through. Hairline crazing across the surface, cracks along the trims and soft spots underfoot all point back to one of these.
A failed GRP roof is often blamed on the material, when the real cause was the installation. Our guide to GRP fibreglass flat roof cost explains what goes into doing it properly.
GRP suits balconies and roof terraces, roofs with lots of corners, and dormers where the trims need to be formed neatly. On a simple rectangular garage, EPDM rubber roofing or modern felt flat roofing may give you a lower price for a roof that does the job. We set out the options in the quote, and our flat roofs page covers repairs across all systems.
GRP stands for glass reinforced plastic. A GRP roof is built on site from polyester resin and a glass fibre mat, which cure into a hard, one-piece laminate across the whole roof, then sealed with a coloured topcoat. A GRP flat roof is simply a flat roof finished this way rather than in felt or rubber.
A properly installed GRP roof can last 25 to 50 years. Most early failures come from laying in poor conditions or on a damp or unsound deck, which is why preparation matters as much as the resin.
It is not something we recommend. Felt laid over a failing fibreglass roof traps any moisture already in the deck and hides the cause of the problem. If the GRP has failed, the honest fix is to repair it properly or strip it and lay a new roof.
Both are long-lasting. EPDM rubber is usually the lower cost and goes on in one sheet. GRP is harder wearing and better if the roof will be walked on, such as a balcony. Our EPDM vs GRP guide compares them in detail.
Often, if the fault is local: a cracked edge trim, a crazed patch or a joint that has opened. The area is ground back, a new laminate laid over it and topcoated. If the laminate is delaminating across the roof or the deck below is soft, replacement is the better spend.
Tell us about your roofing job and we'll get back to you as soon as possible.