What it costs to fix leaking joints, sagging runs and broken downpipes, and when a full replacement is the cheaper answer.
Call 07476 888638 for a free, no-obligation quote. Available Mon–Sun, 9am–6pm.
Guttering is the least glamorous part of a roof and the part that causes the most expensive secondary damage when it fails. Water running down a wall for two winters will do more harm than a slipped tile ever will — soaked masonry, rotten fascia and, eventually, damp inside.
The good news is that gutter work is one of the cheaper jobs on a house. Here are the numbers we work to locally.
Prices assume standard two-storey access on a domestic property. Terraces requiring scaffold or roof access, and three-storey properties, sit above these ranges.
Repair a gutter when the system is otherwise sound: a joint has failed, a bracket has pulled out, a downpipe has cracked. These are quick, cheap fixes that restore performance for years.
Replace when the plastic has gone brittle and chalky, when the run has sagged because the fascia behind it is soft, or when you are on the third repair in as many years. Old uPVC becomes UV-degraded and will crack again next to whatever you have just fixed.
One important check: if the gutter has been leaking against the fascia for a while, the timber behind it may already be rotten. Fitting new guttering onto rotten fascia is a wasted spend, which is why we always check the board before quoting.
A 112mm half-round gutter is the standard on most homes, but on a large roof slope, a steep pitch, or a property that catches heavy rain off a valley, it can simply be too small. In those cases the correct fix is a deeper profile such as a 115mm or 120mm square or high-capacity section, not another clean.
Falls matter too. A gutter should fall consistently towards the outlet, roughly 1:600. Runs that were fitted level, or that sag in the middle, hold water permanently — which is what makes joints fail early.
Two clears a year — one after leaf fall in late autumn, one in spring — keep most systems working indefinitely. Properties with overhanging trees in areas like Sketty, Killay and the Clyne valley need the autumn clear without fail.
Gutter guards can help, but cheap mesh often makes things worse by trapping debris on top where you cannot see it. If you fit them, choose a system you can still inspect.
Tell us about your roofing job and we'll get back to you as soon as possible.
Typically £70–£140 for a single joint, less per joint if several are done in the same visit. If the union itself is brittle, replacing it is more reliable than resealing.
Twice a year for most properties, and always after autumn leaf fall. Homes under trees or near the coast benefit from a third check after winter storms.
On most two-storey homes, yes — we use ladders and towers safely for straightforward runs. Full roofline replacement on a three-storey property normally needs scaffold, which we price transparently.
On a period property or an exposed elevation, often yes. Aluminium and cast-iron-effect systems last far longer than uPVC and do not go brittle, but the up-front cost is two to three times higher.
Covering Swansea, Neath Port Talbot and West Glamorgan.