Shed roof replacement: old felt stripped, boards checked and renewed, new felt or EPDM fitted. Free inspection and written quote. Call 07476 888638.
Call 07476 888638 for a free, no-obligation quote. Available Mon–Sun, 9am–6pm.
Shed roof replacement means stripping a worn covering, checking the boards and timbers underneath and fitting a new roof that keeps water out. Sheds, workshops, summer houses and outbuildings can be re-covered in felt or EPDM rubber, depending on how the building is used.
We check the roof boards, the timbers carrying them and the walls they sit on before quoting. On the day the old covering comes off, soft or broken boards are replaced, the surface is prepared and the new felt or EPDM is laid with proper laps or a single sheet, then finished with edge trims so water drips clear of the walls.
Most shed roofs are covered in a thin mineral felt nailed to timber boards. Over time the felt cracks, the nail heads lift and the edges tear in the wind. Once water gets under it, the boards soften and the roof starts to sag or leak at the joints. Moss and leaf debris hold water on low pitches and speed this up.
Shed roof felt sold for DIY is fine for a basic garden store, but it has a short life on a building you use every day. If the shed holds tools, bikes, a workshop or an office, a better covering is worth considering at the point of replacement.
A modern torch-on or heavier-grade felt gives a tougher, longer-lasting finish than standard shed felt, and suits pitched and low-pitched shed roofs. EPDM rubber is laid as a single sheet with no joints across the roof, which suits flat and low-pitched outbuildings well. Read more on our felt roofing and EPDM rubber roofing pages.
The right choice depends on the pitch, the size of the roof, how long you want it to last and how the building is used. A small garden store and a heated garden office have very different needs.
A new covering is only as good as the deck it is fixed to. Thin or soft boards flex when walked on, split at the fixings and hold damp against the new covering. During a shed roof replacement the deck is checked once the old felt is off, and any boards that are rotten or broken are replaced so the new roof has a firm, even surface.
If the timbers carrying the boards or the walls themselves are badly decayed, re-roofing alone may not be the best use of money. The inspection should tell you honestly whether the roof is worth renewing on the existing building.
A garden shed is usually a lightweight timber building with a small roof. Garages are often masonry or concrete sectional buildings with bigger spans and different roof constructions, so they are covered separately on our garage roof replacement page. For flat roofs on extensions and dormers, see flat roofs.
When you get in touch, tell us roughly how big the shed is, what the roof is covered in now, whether it is pitched or flat and how the building is used. Photographs taken from the ground are helpful. Please do not climb onto an old shed roof to check it.
The old covering is stripped, the roof boards are checked and any rotten ones replaced, then the new felt or EPDM is laid and finished with edge trims. Waste from the old roof is cleared away.
A typical garden shed roof is a short job once the materials are on site, while larger workshops or roofs needing new boards take longer. The written quote sets out the expected timeline for your building.
The roof size and pitch, the covering chosen, how many boards need replacing and how easy the shed is to reach all affect the price. A free inspection means the quote reflects the actual roof.
Good-quality felt suits most pitched shed roofs and is a cost-effective choice. EPDM is laid as a single sheet and suits flat and low-pitched roofs, especially on buildings used as workshops or offices. The pitch and how you use the building usually decide it.
Tell us about your roofing job and we'll get back to you as soon as possible.