One tile out of place is a small repair. Left through a winter, it becomes several.
Call 07476 888638 for a free, no-obligation quote. Available Mon–Sun, 9am–6pm.
Tiles and slates slip for a limited number of reasons: the fixings have corroded, the batten behind them has decayed, or wind has lifted them at an exposed edge. On older slate roofs, nail fatigue is the most common cause of all.
The reason it matters is what sits underneath. Once the covering is breached, the felt takes the water, and felt is a secondary barrier, not a permanent one.
Nail sickness describes the point at which the original fixings have rusted through. It tends to affect a whole roof at a similar age, which is why slates often start to slip in ones and twos and then accelerate. Batten decay does the same thing from a different direction — the nail is fine, but there is nothing sound to hold it.
Water reaches the felt and finds any existing tear. Wind gets under the neighbouring tiles at the exposed edge and lifts them too. On a slate roof, a slipped slate frequently slides and cracks the ones below it on the way down.
A single slipped slate is refixed with a tingle or, where access allows, renailed to sound batten. Where several have gone in the same area, the right answer is usually to open up that section, check the battens and refix properly rather than repeatedly returning for individual slates.
Tell us about your roofing job and we'll get back to you as soon as possible.
It is not an emergency, but it should not wait for spring. The exposed edge is what turns one missing tile into several.
Often yes for common concrete and clay profiles, and reclaimed slate is widely available. Where an exact match is not possible we will say so before starting.
Not by itself. If slates are slipping across the whole roof at once, that points to nail fatigue and is worth assessing properly.
Covering Swansea, Neath Port Talbot and West Glamorgan.