The valley is the busiest few metres on any roof, and it fails long before the tiles either side of it do.
Call 07476 888638 for a free, no-obligation quote. Available Mon–Sun, 9am–6pm.
Roof valley repair usually means lifting the tiles or slates either side, renewing the lining (lead, GRP or a dry valley system) and relaying the tiles with the right cut and gap. Patching a leaking valley with sealant or mortar rarely lasts, because the valley carries the water from two whole roof slopes.
Answer first. If your leak sits where two roof slopes meet, the valley lining has almost certainly reached the end of its working life or is being overwhelmed. Valleys collect the run off from two whole roof planes and funnel it into one narrow channel, so they carry more water, more grit and more moss than anywhere else on the building.
This matters because a valley is a repairable component. You are not usually looking at a new roof. You are looking at relining a channel and resetting the tiles or slates that dress into it.
Older properties around here typically have lead lined valleys. Newer work may use a preformed GRP or fibre cement valley trough, or an open metal valley. Each fails in its own way.
Some people call a valley a roof gully. Either way, there are three common repairs. Clearing debris and refixing slipped tiles at the edge of the valley deals with blockages and overflow. Renewing the lining deals with split lead, perished felt or cracked GRP. Converting to a dry valley replaces mortar bedded tiles with a mechanically fixed system that needs no pointing.
Which one is right depends on the lining and the tiles, which is why we look at the valley from the roof and from the loft before quoting.
The clue is usually inside. Get into the loft with a torch on a dry day and look at the valley board and the rafters either side of it.
You can clear the bottom of a valley where it discharges into the gutter, if you can reach it safely from a properly footed ladder against the gutter and not against the roof. Anything further up the channel means being on the roof, and that is not a homeowner job. Valleys are slippery even when dry, because of the moss they collect.
Do not be tempted by sealant or bitumen paint along a split lead valley. It sticks for a season, then peels at the edges and holds water behind it, which usually makes the leak worse than it was.
A proper valley repair means stripping the tiles or slates back on both sides, removing the old lining, checking and replacing the valley boards if they are soft, then laying a new lining in bays with laps in the direction of flow so nothing runs uphill through a joint.
The tiles then go back with a clean cut line and enough width in the channel to carry the water. On slate roofs a secret or close mitred valley can be reformed, though an open lead valley is usually the more forgiving choice for the weather we get. Where the surrounding covering is near the end of its life anyway, we will say so, because relining a valley into brittle old tiles risks breaking more than it fixes.
Tell us about your roofing job and we'll get back to you as soon as possible.
Stripping the tiles either side, checking the boards, fitting a new lining and relaying the tiles. Minor blockages can sometimes be cleared without stripping.
People use both words for the channel where two roof slopes meet. The repair is the same.
A well laid lead valley in short bays can run for decades. One long unbroken sheet, or lead that is too thin for the run, tends to split much sooner because it has nowhere to expand.
Not properly. The lining runs under the tiles on both sides, so getting at it means lifting them. Anyone offering to fix a valley from on top with sealant is buying you a few months.
Leaf fall. A channel that copes fine in summer dams up once it fills with debris, and the water then runs sideways under the tiles instead of down to the gutter.
It is urgent if water is running onto a ceiling or near electrics. Otherwise it is a job to book promptly, because the valley boards and rafter feet rot quickly once they stay wet.
Yes. Slate valleys need more care because the slates are cut and mitred, but the principle is the same: new lining, sound boards, correct laps and a clean channel.
Covering Swansea, Neath Port Talbot and West Glamorgan.