A side-by-side comparison of the two options for extensions, garages and dormers — with the cost and lifespan figures that usually decide it.
Call 07476 888638 for a free, no-obligation quote. Available Mon–Sun, 9am–6pm.
Most people asking this question are building or replacing an extension roof, a garage roof or a dormer. The answer is rarely about taste; it comes down to the span, the height available under the eaves of the existing house, the budget and how long you intend to stay.
Flat roofs have a poor reputation in the UK, largely earned by decades of cheap single-layer felt. Modern systems are a different proposition entirely — but pitched roofs still win on longevity, and there are situations where only a pitch will do.
Figures below are indicative for a typical single-storey rear extension roof of around 20m² in the Swansea area.
If the extension sits beneath a first-floor window, under a low eaves line, or wraps around a corner where a pitch would look awkward, a flat roof is usually the only practical option. It is also the cheaper option by a clear margin, and modern EPDM and GRP systems installed properly give twenty to thirty years of service.
Flat roofs also open up design options a pitch cannot: a lantern or a run of flat rooflights over a kitchen extension delivers far more daylight than a pair of Velux windows in a slope.
If you have the height, a pitched roof is the better long-term asset. It sheds water by geometry rather than by membrane, matches the main house visually, and typically outlives two flat roof coverings.
It also creates a ventilated void that handles condensation more forgivingly, and it gives you a warm, conventional loft space above the extension for services.
On a house you intend to keep for twenty years or more, the whole-life cost of a pitched roof is often lower despite the higher up-front price.
Both options must meet current thermal standards for a new or replacement roof to an extension. On a flat roof this normally means a warm-deck build-up with rigid insulation above the deck; on a pitched roof, insulation between and over or under the rafters.
Warm-deck flat roof construction adds height and cost but avoids the condensation risk of older cold-deck designs. We would not build a new cold-deck flat roof today.
This is a common request on garages and 1970s extensions, and it is often achievable. The existing walls and foundations need checking for the additional load, and the new pitch must not block windows or breach the eaves line of the main house.
Where a full pitch is not possible, a low-pitch tiled system can sometimes be used at angles down to around 12.5 degrees with the right interlocking tile. That gives much of the appearance and durability benefit without the height.
Tell us about your roofing job and we'll get back to you as soon as possible.
No. Old single-layer mineral felt leaked. A correctly installed EPDM or GRP warm-deck roof with adequate falls and a properly formed outlet is a reliable twenty-to-thirty-year covering.
Design falls of 1:40 are recommended so that a finished fall of at least 1:80 is achieved after deflection. A genuinely level roof will pond and fail early.
Usually yes, subject to the walls being able to take the load and the new ridge height not obstructing windows. We survey the structure before quoting.
A pitched roof generally reads as more permanent to buyers and surveyors, but a well-executed flat roof with a lantern over a kitchen extension can add more usable appeal.
Covering Swansea, Neath Port Talbot and West Glamorgan.