Standing Water on a Flat Roof: Why It Happens and How to Fix Ponding

Puddles that are still there days after the rain has stopped mean the roof is not draining as designed.

Call 07476 888638 for a free, no-obligation quote. Available Mon–Sun, 9am–6pm.

Standing water on a roof that is still there a couple of days after rain means the roof is not falling to its outlet properly. To fix ponding on a flat roof, the cause has to be found first: a blocked outlet, a sagging deck, or a covering laid without enough fall. Clearing the outlet sorts the first; the other two need the deck or the fall corrected, not another coat on top.

Answer first. Water sitting on a flat roof for more than about forty eight hours after rain is called ponding, and it is a fault rather than a feature. A flat roof is never truly flat. It is built with a slight fall, usually around 1 in 80, so that everything it collects runs to an outlet.

Ponding on its own does not necessarily mean the roof is leaking today. What it does mean is that the covering is being asked to sit in water, and that is the condition every flat roof material likes least.

What causes water to stand still

There are only a few real causes, and telling them apart changes the cost of the fix considerably.

  • Not enough fall was built in when the deck was laid, so the roof drains slowly everywhere
  • The deck has deflected between joists, creating a dish in the middle of an otherwise sound roof
  • Insulation below the covering has taken up water and compressed, which deepens the dip
  • A blocked outlet, gully or rainwater shoe, so the water has nowhere to go
  • A joist or firring piece that has decayed, dropping one area lower than the outlet
  • A parapet or upstand detail that dams the water back rather than letting it off the edge

How to fix ponding on a flat roof, cause by cause

A blocked outlet or gutter is the cheapest fix and the first thing we check. Leaves, moss and grit collect at the lowest point, and once the outlet is clear the water often goes within the hour.

Where the deck itself has dipped, usually because boards have got wet and softened, the soft area is cut out and new deck laid before the covering is renewed over it. Covering over a soft deck just moves the pond.

Where the roof was laid dead flat, the fix is to build the fall back in with tapered firrings or tapered insulation, then lay the new covering. On a small garage or extension this is often the point where replacement makes more sense than repair.

What ponding actually does to the roof

Standing water adds weight, and weight increases deflection, which deepens the pond. That loop is why a small dish rarely stays small.

On felt, prolonged wetting softens the surface dressing and blisters and splits appear at the edges of the pond first. On GRP, standing water sits in any low spot around a joint and finds pinholes. On EPDM, the sheet itself copes with water well, but the ponded area collects silt and debris that traps moisture against seams and terminations. In every case the trapped water also freezes in winter, and ice is what turns a hairline fault into an open one.

What you can check yourself, safely

If the roof is a garage or an extension you can see from an upstairs window, look from there. Do not walk on a flat roof you do not know the construction of, and do not walk on one that is wet, iced or covered in moss.

  • Photograph the roof from a window a day or two after heavy rain and mark where the water is
  • Check the outlet or gully for leaves, moss and grit, since a blockage is the cheapest possible cause
  • Look for a dark tide line, which shows the pond is a regular event rather than a one off
  • Inside, check the ceiling below the pond for staining, and note whether the plaster feels soft

How it gets put right

A blocked outlet is a morning's work. A dish caused by deflection needs the covering lifted locally, the deck inspected and the fall rebuilt with firrings or tapered insulation before a new covering goes on. Where the deck itself is soft underfoot, that section of boarding is renewed, because no membrane laid over a rotten deck will last.

Sometimes the honest answer is that the fall was never adequate and patching will only buy a season. We will say so, and we will tell you what a new covering with a properly built fall would cost so you can decide with the numbers in front of you.

Want a professional to handle it?

Get Your Free, Personalised Quote

Tell us about your roofing job and we'll get back to you as soon as possible.

No spam, no obligation. We'll get back to you as soon as possible.

Free Inspections
Fast Response
Reliable Workmanship
West Glamorgan Coverage

Questions

Is standing water on a flat roof normal?

A thin film that dries within a day or so is normal. Water that is still sitting there after that is ponding and should be looked at.

Can ponding be fixed without replacing the whole roof?

Often, yes. A blocked outlet or a small dip can be put right on its own. A roof laid with no fall at all usually needs the fall rebuilt, which means a new covering.

Why does my flat roof leak only in heavy rain?

Heavy rain fills a pond deeper and faster than the outlet can clear it, so water reaches a weak seam, an upstand or a flashing that stays dry in light rain. An outlet that is partly blocked or too small for the roof has the same effect.

How do you fix ponding on a flat roof?

The cause is fixed first. A blocked outlet is cleared or improved, a dipped or soft deck is cut out and renewed, and missing falls are built back in with firrings or tapered insulation before the roof is re-covered. Adding coating over the pond does not fix it.

How long can water sit on a flat roof before it is a problem?

As a rule of thumb, anything still there two days after the rain stopped counts as ponding and is worth looking at.

Does ponding mean my flat roof needs replacing?

Not always. If the cause is a blocked outlet or a single low spot, a local repair and a corrected fall can be enough. It is a replacement conversation when the deck is soft or the fall was never built in.

Can I just add more coating over the pond?

Coating a wet, low area traps moisture underneath and usually fails at the edges. The fall has to be fixed first, otherwise you are painting over the cause.

Is moss on a flat roof a sign of ponding?

Often, yes. Moss and silt collect where water lingers, so a green patch is a good map of where the roof is not draining.

Which flat roof system handles slow drainage best?

EPDM and good quality felt both cope better than GRP with occasional standing water, but no system is designed to sit in it permanently. Drainage comes first, material second.

Related services