Cheeks, apron, soakers, the small roof above and the window itself. One of the five is letting go.
Call 07476 888638 for a free, no-obligation quote. Available Mon–Sun, 9am–6pm.
Answer first. A dormer is a small building sitting on a roof, and every edge where it meets that roof has to be weathered. There are typically five candidates for a leak: the cheeks at the sides, the apron at the front, the side soakers or step flashings, the small roof over the dormer, and the window unit itself. Nothing else is usually involved.
That is why dormer leaks are so often misdiagnosed as window failures. The window is the thing you can see, so it gets blamed. In practice the flashings and the little roof above cause more trouble than the glazing does.
Working from the top down, this is what we check and what failure looks like at each point.
The internal pattern narrows it down before anyone goes near the roof.
Dormers concentrate water. Rain that would spread across a whole slope is funnelled around the sides of the dormer and down into the small gutters and junctions either side of it. More water, more often, through details made of short pieces of lead with a lot of joints.
Add to that the fact that dormers are often the part of a roof that has been altered, particularly on loft conversions, and you get details that were formed quickly, sometimes with mortar where lead should be. Any cement fillet around a dormer is a temporary detail whether it was sold as one or not.
From the ground or an opposite window with binoculars, and from inside the room, you can gather most of what a roofer needs. Do not lean out of a dormer window to inspect its own roof.
Note the weather each time the leak appears, including wind direction, and photograph the internal staining with a date. If the dormer is part of a loft conversion, it also helps to know roughly when the work was done.
Most dormer leaks are put right by renewing lead: a new apron dressed correctly over the tiles, new soakers stepped into the brick or blockwork joints, or a new covering on the dormer roof with upstands taken high enough to keep driven rain out.
Where cheek cladding has slipped, that section is stripped, the sarking or boarding checked, and the cladding refixed properly. If the timber inside a cheek has been wet for years there may be repair work behind the cladding, and we would rather find that at the quoting stage than surprise you with it mid job.
Tell us about your roofing job and we'll get back to you as soon as possible.
Where the water shows tells you a lot. Damp at the head or in the ceiling inside the dormer points at flashings or the dormer roof. Damp only at the cill, with nothing above it, is more likely the unit or condensation.
Driven rain hits one cheek and one side of the flashings. If a soaker is dressed too shallow, water gets pushed over the top edge on that side only.
It is often found there, but it cracks away from the surrounding materials and then leaks. Lead flashings dressed into the joints are the durable detail.
Not always, but conversions are where we most often find rushed flashing details. Age, movement and slipped cladding cause plenty of dormer leaks on original dormers too.
Usually some form of safe access is, because dormer work means working on the slope beside it. We include access in the written quote so there are no additions later.
Covering Swansea, Neath Port Talbot and West Glamorgan.