Nine times out of ten it is the junction with the house, not the roof panels themselves.
Call 07476 888638 for a free, no-obligation quote. Available Mon–Sun, 9am–6pm.
A leaking conservatory roof is most often a failed seal or gasket, a blocked or leaking gutter, or the flashing where the conservatory meets the house wall. Water can also track along the glazing bars and drip well away from the actual fault, so the drip point is not always the place to repair.
The answer up front. Conservatory and single storey extension roofs rarely leak through the middle. They leak where they meet something else: the wall of the house, the ring beam at the eaves, or a rooflight kerb.
That is useful, because those junctions are repairable details. It also explains why people who spend a fortnight sealing panel joints often find the drip exactly where it was.
We look at these in roughly this order, because that is the order they tend to fail in.
Never stand or lean a ladder on a conservatory roof: the panels and bars are not made to take weight. From the ground and from inside you can check whether the gutter is full, whether the wall flashing looks cracked or lifted, and whether the leak lines up with a glazing bar or the wall join.
If it appears only in wind driven rain, the wall flashing is the first suspect. If it appears in any rain, look at the gutter and the seals first.
This is the single most common source. The correct detail is a lead or purpose made flashing dressed down over the roof and tucked into a raked out joint or into a proper cavity tray, so water running down the house wall is thrown clear of the conservatory.
What we often find instead is a bead of mastic or a cement fillet, sometimes both, applied over the years by whoever was last asked to stop the drip. Mastic hardens and cracks. Cement cracks where it meets aluminium or PVC because the two move at different rates. Once either cracks, the water runs behind and appears well away from the crack.
Most of this can be done from inside the conservatory or from an upstairs window.
Depending on what we find, that means forming a proper flashing at the wall instead of mastic, renewing panel gaskets and end closures, or resetting the eaves gutter so it drains the way it was meant to.
Where the roof is a tired polycarbonate one and the frame is sound, some owners choose to replace the covering rather than keep chasing seals. If you are thinking that way we will tell you honestly what the existing frame and beam can carry, and we will not talk you into work the structure does not support.
Tell us about your roofing job and we'll get back to you as soon as possible.
Usually the lead or flashing at the wall has cracked or pulled away, or water is running down the wall above and getting behind it.
In many cases, yes, by renewing seals, clearing the gutter or replacing the wall flashing. We look at it first and tell you which applies.
That pattern often points at a wall junction rather than the panels. Wind-driven rain can enter a failed flashing and appear inside away from the opening.
Condensation appears as a film or many small droplets on the inside of the glazing, worst in cold weather and often when the room is unheated. A leak follows the rain and tends to run from one point.
Mastic buys time at best. It hardens, cracks and then hides the water path. A lead or purpose made flashing tucked into the brickwork is the detail that lasts.
Yes. Polycarbonate needs its end closures and gaskets treated as consumables, because once the flutes fill with dirt and water the sheets stain and sag.
Sometimes that is the better spend, particularly if the panels are heavily discoloured and the seals are all perished. It depends what the existing frame and ring beam can support, which we check before advising.
Covering Swansea, Neath Port Talbot and West Glamorgan.