Common Flat Roof Problems and Their Fixes

Most flat roof trouble comes from a short list of faults. Knowing which one you have tells you whether a repair will hold or the covering has had its day.

Call 07476 888638 for a free, no-obligation quote. Available Mon–Sun, 9am–6pm.

The most common flat roof problems are standing water, blistering or cracking of the covering, failed joints and upstands where the roof meets a wall, worn edge trims, and a soft or rotten deck underneath. Each has its own fix, and only the last one, a failing deck, normally forces a full replacement on its own.

Below we go through each fault in the order we tend to meet them on garages, extensions and dormers around Swansea and Neath Port Talbot, what causes it, and what a proper repair looks like.

1. Water that sits on the roof

A flat roof is never truly flat. It is built with a slight fall so rain runs to a gutter or outlet. When the deck sags, or an outlet is blocked, water collects in shallow pools and stays there for days after rain. Standing water is heavy, it speeds up wear on the covering and it finds any weak joint in the area.

The fix depends on the cause. A blocked outlet or gutter is simply cleared. A dip in the deck needs the boards underneath corrected or built up with tapered insulation so the fall works again. Patching the covering in the pool without dealing with the fall only moves the problem a few feet.

2. Blisters, bubbles and cracking

Older felt roofs develop raised blisters where moisture or air has been trapped between layers and expands in the sun. Over time the surface also dries out and cracks, especially on south facing roofs. A single sound blister is not an emergency, but a roof covered in them, or with cracks you can see daylight in, is near the end of its life.

Isolated blisters can be cut, dried and sealed. Widespread cracking is usually the point to replace the covering, and most people choose EPDM rubber or GRP fibreglass rather than felt again, because both are laid with far fewer weak points.

3. Upstands and wall junctions

Where a flat roof meets a house wall, the covering is turned up the wall and protected by flashing. This junction moves as the building expands and contracts, and it is the single most common place for a leak we trace. The symptom is often a damp line on the ceiling next to the wall rather than in the middle of the room.

A proper repair renews the upstand and the flashing above it together, so the water is shed over the joint rather than relying on sealant alone.

4. Edge trims and drip details

The trims around the edge of the roof hold the covering down and throw water clear into the gutter. When they lift or corrode, rain is driven back under the membrane and into the fascia board. You may notice stained fascias or a gutter that overflows at one end.

Trims can often be renewed on their own if the covering behind them is sound. On a replacement they are always fitted new as part of the finish.

5. A soft or rotten deck

If water has been getting through for a season or two, the timber boards under the covering soak it up. From inside they can look fine. Underfoot they feel spongy. A new membrane cannot be laid over timber that gives, so soft boards have to be replaced first.

This is the fault that most often turns a repair into a replacement, and it is why we check the deck before we quote rather than guessing.

Repair or replace?

As a rough guide, one clear fault on an otherwise sound roof is worth repairing. Several faults at once, a covering that is cracked all over, or a deck that is soft in more than one place usually means replacement is the better use of money. Felt tends to last 10 to 15 years; a properly installed EPDM or GRP roof can last 25 to 50 years, which is why a replacement is often cheaper over time than a string of patches.

Want a professional to handle it?

Get Your Free, Personalised Quote

Tell us about your roofing job and we'll get back to you as soon as possible.

No spam, no obligation. We'll get back to you as soon as possible.

Free Inspections
Fast Response
Reliable Workmanship
West Glamorgan Coverage

Questions

Can a flat roof be repaired rather than replaced?

Often, yes. A single split, a failed upstand or a blocked outlet can be repaired on its own. We only recommend replacement when the covering or the deck has failed across the roof.

Why does my flat roof only leak in heavy rain?

Usually because water is building up and reaching a weak joint, an upstand or a lifted trim that stays dry in light rain. Standing water makes this much more likely.

Which flat roof system do you use for replacements?

We fit EPDM rubber, GRP fibreglass and high performance felt, and recommend one based on the size of the roof, how it is used and your budget.

Is the inspection free?

Yes. We look at the roof, explain what we find with photos and put a fixed price in writing with no obligation.

Related services