The chimney is the most exposed masonry on the house and the most common source of a persistent roof leak. Here is how to tell what yours needs.
Call 07476 888638 for a free, no-obligation quote. Available Mon–Sun, 9am–6pm.
A chimney stack gets weather on all four sides, has no roof over it, and carries the flashings that keep water out of the roof around it. It is unsurprising that stacks are where we find so many leaks.
Work on a chimney falls into four levels: repointing, re-flaunching, partial rebuild and full rebuild. Correctly identifying which one you need can be the difference between £600 and £3,500.
Look at the mortar joints first. If the pointing has receded so that you can push a key more than about 10mm into the joint, or if it crumbles when you touch it, the stack needs repointing.
Then look at the top. The flaunching is the sloped mortar bed the pots sit in. Cracked or missing flaunching lets water straight into the top of the stack, where it soaks down through the brickwork and appears as damp on the chimney breast inside.
Finally, look at the bricks themselves. Spalled, blown or frost-damaged faces mean water has been in the masonry for years, and repointing alone will not fix a stack whose bricks have failed.
Chimney costs are dominated by access. Once scaffold or a tower is up, doing everything the stack needs in one visit is dramatically better value than returning.
The most common mistake on older chimneys is repointing with a strong modern cement mix. Hard cement on soft Victorian brick traps moisture in the brick, which then spalls when it freezes — the pointing survives and the bricks destroy themselves.
On a period stack the correct approach is a lime-based mortar, or at least a weak, sand-rich mix with a low cement content, so that the mortar remains softer than the brick and acts as the sacrificial element.
On post-war brickwork a conventional mix is fine. Knowing which you have is part of the job.
If you have damp appearing on a chimney breast, there are three usual culprits: cracked flaunching letting water in at the top, failed pointing letting it in through the sides, or failed flashings letting it in where the stack passes through the roof.
Very often it is all three, because they have the same cause — decades of weather with no maintenance. That is why repointing and re-flashing are usually quoted together.
One more cause worth knowing: a disused flue that has been sealed at the bottom but left open at the top collects rain for years. Capping the pot while retaining ventilation solves it.
If the chimney is redundant — no fires, no boiler flue, no plans to reinstate — removing it to below the roof line and tiling over is a legitimate and often cheaper long-term option.
But it is not free of consequences. The stack may be providing ventilation to the flue and to the roof space, it may be shared with a neighbour in a terrace, and its removal changes the appearance of the property. On period houses, keeping and repairing the stack is usually the better decision.
Tell us about your roofing job and we'll get back to you as soon as possible.
Typically every 25–40 years on an exposed West Glamorgan stack, sooner near the coast. Flaunching generally needs attention more often than the pointing.
Not properly. Working safely on all four faces of a stack requires a scaffold or a suitable tower, which is why access forms a real part of the cost.
Yes, with a ventilated cowl. Sealing it completely traps moisture in the flue and causes damp on the breast; a ventilated cap keeps rain out while allowing air movement.
Most often cracked flaunching, failed pointing or failed lead flashings — sometimes all three. Occasionally it is hygroscopic salts from historic soot, which is a different repair entirely.
Covering Swansea, Neath Port Talbot and West Glamorgan.